How to build corner cabinet china – Place the table saw guide to 20 inches. Place the square edge of one of the pieces from step 1 again against the fence and rip the plywood. Measure the width of the wide point of the miter to the edge of the square. Must be 20 inches. Place the table saw guide in 19 1/4 inches. Place the square edge of the other piece from step 1 again against the fence and rip the plywood. Measure the width of the wide point of the miter to the edge of the square. Must be 19 1/4 inches.
Corner cabinet china set the table saw to 2 1/4 inches. Part Rip January 2-by-3-by-72-inch lumber. These are the end pieces to the frame. Set the circular saw blade back to 90 degrees. Then set the guide bar 24 inches on the left side of the sheet (ie, above the blade). Cut two pieces created from steps 1 to 3 across the grain. This should give a length of 72 inches for the two pieces. These are the extreme corner of the box. Place the two pieces so that the long side of the stomach miters. It measures 18 inches from the bottom edge and make a mark. Place the bracket on the mark and draw a line across the width of the plywood.